Smk-link-electronics Universal Projector Remote Control Manuel d'utilisateur télécharger pdf (Page 10)

Page 8

• Press Select, wait one second then press Select a second time.

The LED will then ash the code digit by digit with a one second

delay between each digit. The library code 1 2 1 3 would blink the

status LED.

Flash [Delay] Flash Flash [Delay] Flash [Delay] Flash Flash Flash

Factory Reset

The Universal Projector Remote Control can be reset to factory

default. All user programmed codes and learned codes will be

erased.

• Press and hold both the Up and Down arrows simultaneously for

3 seconds.

• The status LED will turn off while both keys are pressed but will

turn solid red after three seconds.

• Press the Off key

• Wait one second then press the Reset key.

Factory default settings will be set and LED will go OFF to indicate a

successful factory reset.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Smk-link-electronics Universal Projector Remote Control Manuel d'utilisateur Page 10